Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can I use the N7K-M132XP-12 module to connect 1g uplinks from my access switches while we migrate these connections to 10gig one at at time. To retire my old core gear I need to support a mix of both 1g and 10Gig for sometime and was hoping I could ...
I'm looking to use a RPS 2300 to act as a redundant power supply for some 2950 switches in my data center. I figured that they would be able to keep my 4 switches up and running in the event that power was lost to the switches. As long as I have my...
I have two 6509 Sup720 Boxes running IOS 12.2.(18)SXD4. If I do a show run command after making any config change my telnet session will hang. If I open another session I can run other show commands but, If I do show run it will hang again. The bo...
As Cisco continues to push users toward the new Webex (formally Teams) Client. I would have thought this would have been a priority to add into the new rebranded client. The feature not being available in the Webex client is going to be a barrier t...
Check the interface counters for errors. Make sure duplexing is setup correctly. How about a traceroute to make sure that it's taking the best path. After that you might have to do some packet investigation with a sniffer.
