Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have a 4507R+E acting as the core L2/L3 switch with a number of 3650's dotted around the campus. Each 3650 is connected to the core via Fibre. For reasons I won't go into, we have around 100 PVLAN's, basically one per classroom. Our DHCP ser...
Hi everyone,
We have a CUCM/CUC 11.5.x (latest release) with a few different types of phones, 8861,88417821 and 8821 wireless phones.
Our wireless network is not Cisco. The phones are connected to a hidden SSID with WPA2-PSK.
The issue I am exp...
Hi,
I'm on the home stretch of this Call Forward All nightmare. I can now successfully receive a diverted call:
External A calls Internal B and is diverted to external C - however only when the SIP trunk is configured for "Last Redirect Number - Ex...
Hi,
I have a working diversion, however the method used is hard-set to one extension leaving all calls forwarded to showing one number as the diverted party. I would like to have the diverted number shown for the DiD of the correct user. Below is th...
Hi,
I've been messing with CFA for a few days now and getting nowhere fast. Speaking with the ITSP I can confirm they do not allow P-Asserted methods but they DO allow Diversion modifications to the SIP header.
They are telling me that the issue is...
Hi Paul,
From what I can tell it's only WiFi clients on the .16 subnet. Having said that, the lease time for wired clients is considerably longer, 3 days opposed to WiFi clients at 8 hours.
There are no duplicate DHCP addresses or DNS entries.
...
Thank you for your replies, and my apologies for the late reply, it was quite hectic last week.
In answer to the suggestions:
I haven't been able to run any packet captures. As soon as it goes down 1200+ people are offline, so the pressure is on ...
For any edge device to access the internet the private address will need to be translated to a public 'routable' address. This is accomplished via NAT (Network Address Translation). You will need a device that is capable of NAT and routing. Think bac...
I remember the article you're referring to, and from memory, it required some hacking of root access to get to the files in question. I too have been looking to replace some of the built-in messages, no luck thus far. With regards to the "Wait while....
