Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
LMS 4.1 Configuration, Troubleshooting and Best Practices. Open this guide on your LMS server and the links inside will take you directly to the corresponding pages on your LMS server.
Hi Graeme,I meant "sh env", not "sh ver". Sorry about that.The "Relative temperature threshold" is how close the current temperature value can be to the system major alarm before LMS triggers an alarm. The system major alarm is the threshold that tri...
Hi Graeme,The entSensorValue and CurrentValue show the current temperature value, not the temperature value that was there when the event was triggered. So although DFM is showing 46.0 DEGC now, the temperature was probably higher at the time when th...
Hi Steve,LMS does not support software management for the WLSE devices. LMS only supports Topology Services for WLSE. Here is a list of supported features:http://www.cisco.com/en/US/docs/net_mgmt/ciscoworks_lan_management_solution/4.0/device_support/...
Hi Michal,Live Graph It only monitors the interfaces that instantiated in the ifTable and have an ifOperStatus and ifAdminStatus that are up. To check if the device is populating the ifTable correctly, go to Device Center, select the device and perf...
