Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Should default QoS for FCOE be automagically created when one enables feature fcoe ?I've just worked a problem where it did not, adding default FCOE QoS fixed the issue and allowed vfc's to come up...Only thing I can think of is that I had previously...
Is the N2148K connected to a the N7K M1 line card a supported configuration? I do not see it listed in the support matrix listed here, http://www.cisco.com/en/US/prod/collateral/switches/ps9441/ps10110/data_sheet_c78-507093.html But from the N7K con...
Guys, Are you configuring Callhome in every VDC or just the admin VDC? I'm wondering if I'm getting anything useful out of having a separate Callhome configuration in all 3 of my VDC's.I'm not using CFS to distribute either, I also wonder if I should...
Hi, I'm having trouble getting my ACE 4710 configured - you can ping the VIP but cannot http to the VIP address and see the servers. I have an admin network, a client network and a server network - all with layer 3 interfaces on my 6509 that connects...
I have a new OSPF connection to an external business partner. The OSPF adjacency is FULL/DR and I can see LSA in database but nothing in the route table. I have tried different OSPF network types but nothing works. I've looked at the Cisco doc here h...
Hi, I found a problem with the Vlan85 interface - it was set to trunk. I changed it to access and for a moment everything was working Now, of course it does not work again. I can ping server to server on the Vlan but not to the Ace. D
Hey Dario, Vlan 14 is doing nothing - cannot delete it though - always get an error that it's in use.I removed the layer3 configuration for vlan85 from the C6500. Changed the Vlan85 interface address on the ACE to 10.65.85.1 (this is the server's def...
Hi Dario, Thanks for your response on this. I think I've configured it the same as your logical diagram above. Although I do not have the server's default gateway as the ACE. I've attached config for the ACE and the 6509. Thanks for your help.D
You might be able to use the qos-group feature to mark each individual tunnel at the spokes, this way you could employ QOS at the hub based on these cos-groups.
