Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hii want to monitor cisco access point using SNMP .These WAP are controlled by two Cisco Controllers (In HA mode ‘Active/Passive)and the protocol used for Controller-WAP communication is CAPWAP . Is that possible or not Somtehin Else can we find an...
Hi Can i limit bandwidth under VLAN Test for example on ASA 5520 means if i have 30 Mb i want to limit this amount to 10 Mb using by Vlan Test is tha possibe if yes can u send the Command line configuration RegardsAhmed
I have a asr 9000 router i want to view the taffic netflow in interfaces using Netflow Analyzer but cant see a lot of traffic evenif we apply command show we see the same result is there a IOS bug ?
Hi Can u ask me about the difference between the ios version 12.2(44)SE2 and 12.2 (55) SE9 and the bug fixed relative to the old version12.2(44) from cisco catalyst 2960 24 PCL RegardsAhmed
HI I would like to supervise the access points and the controller by monitoring application and I would like to know how to enable snmp in the access points(for the case of capwap AP) is that through the controller or independently whether the WLC co...
Hello Tarik we used the redirect and the CWA method instead it works thanks but if the redirect occurs the URL display the name of ISE not the IP ADRESS and the guest user must put the dns manually for the first step and after logging to access inter...
