Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
I'm trying to setup a Port-Channel between one Cisco 4507 and one Huawei 5850. The Cisco switch is running RSPT PVST whereas the Huawei Switch is running MSTP.
Below the configuration of the Cisco:
interface Port-channel20 description *** TO HU...
Hi all,
I'm trying to configure a port-channel between a Cisco Cat 4507 and a Huawei switch; when I try to activate the Po on the Cisco side I got the following error:
*Jun 8 06:27:08.289: %PM-4-ERR_DISABLE: channel-misconfig error detected on Po20...
Hi all,
on a Cisco Cat 4500 I need to replace a line-card with 6 port 1Gbps with a new line-card WS-X4606-X2-E.
Is this possible? Which are the step I need to follow to complete this activity? It is the first time this happens to me.
Thanks for your ...
Hi,
I need to permit traffic from the inside to the outside interface for three specific hosts. Those hosts must be Natted with a specific public IP address.
In your opinion the configuration below could work correctly?
access-list Direttore_Gener...
Hi,
I'm trying to build a configuration for a Cisco Catalyst 4506-E with Supervisor Engine 7-E.
I would ask how licensing works.
I can choose between various Universal Image (for example: S45EU-S7-38E); I cannot find this code in any Cisco document. ...
Hi agapitca19,
thanks for your suggestion but it still doesn't work. I tried to remove on the Huawei side the lacp preempt and priority but same issue.
The port-channel goes up for some second:
*Jun 8 08:16:42.909: %EC-5-BUNDLE: Interface Te1/1 jo...
Hi Mark,
thank you very much for your answer. Regarding the configuration, what will change?
Now I have this module on slot 6:
1000BaseX (GBIC) WS-X4306-GB
And I want to replace it with this, in order to have 10Gb port:
WS-X...
Hi,
thanks for your answer.
I asked to my CA to generate a new certificate with General Purpose usage.
Now they are asking me what should be the "key usage" accepted from our software.
In your opinion what I have to anwer?
Many thanks again.
Mau...
