Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Team, Please my ASR1002 is not loading completely. when accessed via console, the below error message is displaced and i cannot enter rommon mode neither can i do any other thing else from console System Bootstrap, Version 12.2(33r)XNC, RELEA...
Please i need assistance, i have some AIR-LAP1131G-A-K9 that is not joining the controller. I'm currently using Cisco4400 series controller. Note: the AP's are getting IP address via DHCP as the controller and AP's are on same subnet. from the AP, i ...
I'm using Cisco ASR 9001 router, the router is not saving configurations. see below sample configuration. please how can i fix this
RP/0/RSP0/CPU0:LLC-IGW(config-if)#int gig0/0/1/19RP/0/RSP0/CPU0:LLC-IGW(config-if)#no ipv4 addressRP/0/RSP0/CPU0:L...
Please I need assistance, I cannot access the 20 1GB PORTS and the 4 10gb ports from global mode. I have administrative right to the router.
However, if I type interface preconfigure gig0/0/1//1 from the global mode it will take the command but ...
Hi all,I have a 3845 cisco router, i need to block access to sites such as facebook, youtube on the router itself while allowing the executive to have access to these sites. I dont have a firewall for now, can this be achieved on the router. command ...
@Mark Elsen no Error message when power cycle, the device will load and stopped at same message; System Bootstrap, Version 12.2(33r)XNC, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupport Copyright (c) 2009 by cisco Systems, I...
i mean the router got stuck showing this message; System Bootstrap, Version 12.2(33r)XNC, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsupport Copyright (c) 2009 by cisco Systems, Inc. I am logging through console but it won't le...
@Mark Elsen . thanks for your response. The router got stuck during boot process and showing below message via console. basically, it got stuck showing the below message System Bootstrap, Version 12.2(33r)XNC, RELEASE SOFTWARE (fc1)Technical Sup...
Thanks @Leo Laohoo some of the AP's came up after setting the time to a recent earlier time when the certificates were still valid. i will proceed to upgrade software if this will fix completely
