Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am having trouble establishing a neighbor on my ASR9006 with a Brocade device and cannot find any information on what I am seeing in the debug output. Can anyone tell me what the following messages are indicating? This is the only ouput I get from ...
I'm configuring some Nexus 9372PXs running 6.1(2)I3(2). The 6.X configuration guide clearly states that I can create L3 sub-interfaces using the range 1-4094. However, when I attempt to do so, I appear to be getting a limit of 1-511. What am I missin...
I'm configuring some Nexus 9372PXs running 6.1(2)I3(2). The 6.X configuration guide clearly states that I can create L3 sub-interfaces using the range 1-4094. However, when I attempt to do so, I appear to be getting a limit of 1-511. What am I missin...
For many years I have configured HSRP on my IOS based devices with tracking configured for a Loopback without an IP so that during maintenance windows one simply needs to down the loopback to fail HSRP to the peer. However, recently when configuring ...
I have configured a 10G SPAN port on my Nexus 7010 and connected it to a NetOptics SPAN regeneration tap. I am unable to get the SPAN session to come up. When I bypass the tap and connect my monitor server directly to the SPAN port on the Nexus, it w...
There was a COPP style ACL on the Brocade which I had updated appropriately to permit the new BGP session, but did not rebind. Without rebinding, the update was not applied and the session was not permitted. I've had little exposure to Brocade device...
Thank you both for your responses. I figured out my issue - it was on the Brocade end
In any case, I appreciate the info and will refer to these pointers in the future. That being said, is there anywhere that I may have overlooked to get better int...
Can you provide more detail on your solution here? I'm wondering if I can route for the Vlan on the switch module via an SVI on another Core Switch connected via one of the Gig ports on the router. In other words, configure the Gig interface as a tru...
So you are saying that by default the request is forwarded to all relay servers configured? I wonder why I am not seeing a mix of clients across both vlans getting leases from both servers then.
