Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Cisco C6880-X running 151-2.SY3
We we installed OIR a C6880-X-16P10G hot-swappable card and CPU went to 100%, also appears routed SVI's dropped on card install and subsequent card cycle post upgrade. Furthermore, seems L3 routed interfaces stayed onl...
In a partially implemented IOS NAT config like below, BUT you then don't call any specific ip nat outside source static or ip nat inside source route-map nonat does it still call for the packet to be punted to the CPU?interface g0/1desc LANip nat ins...
Currently I have two service providers and two edge routers. RTR1 is iBGP peered to RTR2 and RTR2 is iBGP peered to RTR1. We are planning to install a third service provider and install RTR3. Making sure I have my iBGP mesh setup properly, and also c...
I have multiple ASA5510?s and I would like to offer my customers a SSL/L2TP/PPTP type VPN connection. I have read the papers, and watched the demo?s but just don?t know the best way to accomplish what I would like to do. I would like for it to be the...
That write up is from 2007 and involved 6500's, makes no references to 6800 architectures. I am 100% positive the article correct because we have seen those events in 6500 arch's.
Cisco Live Wargo presentation I didn't notice anything being stated ...
I have more testing to do today for the TAC engineer (not overly helpful, besides the point).
I connected both 10Gb's to a 4500x for testing, after bring up the interfaces and bringing them down all messages seemed to have stabilized. The concept beh...
ROMMON - 15.5(3r)S1IMAGE - asr1001x-universalk9.03.16.03.S.155-3.S3-ext.SPA.bin
Just opened a TAC case, will try to report back after investigations.
To me this is NOT A COSMETIC BUG. The line protocol is going UP with zero items connected.
%LINK-3-...
