Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I inherited an old WLC4402 that is running 4 LAP1142 units. It is working fine, and we're not planning to replace until next year -- until today when the MIC cert expired on the WLC, and the device stopped accepting the AP connections.
I have looked...
We have decommissioned one of our C170 IronPort Appliances and want to wipe the config before disposal. We did both the RESETCONFIG and DIAGNOSTIC | RELOAD, while the running config was cleared, there was still the option to do a ROLLBACKCONFIG and ...
I have a very small location with a 10-User ASA5505. They currently have 2PCs, 1 Printer, a VoIP phone, and an Access Point, with the ASA acting as the local site router. The site works fine, but occasionally they will have a visitor or two that co...
Gmail allows the ability to send using an alternate email address. I have a user that likes using Gmail, but needs to send using our internal email domain address as their send from address. Gmail will send this, but it will come from their Gmail a...
I have a 2900 ISR that my VPN clients connect to using IPSEC over UDP. I am having periodic problems, especially with clients connecting through DSL, where they connect and immediately drop. Sometimes this is resolved by users updating their home r...
I am looking to do something similar, but only want to hold incoming emails for one of many email domains being processed by our IronPort. We are moving one of our email domains to an external Exchange server, and will want to pause delivery of emai...
I figured I'd be fine, but is there any hard confirmation of this 4 hour timer. I cannot find in any Cisco documentation. Also, is that timer something that can be changed via configuration? Ideally, I'd like to have the number closer to an hour.
Thanks, this worked perfectly, as did the failover test. The only open task is to make the new 3750 stack a VTP server (currently a client). Want to change during off hours in case something odd happens and wipes out the VTP configuration across al...
Thanks for the quick response. I was starting down that road, but wanted to make sure it would allow my the ability once configured to hang the edge switches off of the 3750 stack without any issues. I'll start the configuration tomorrow, and try a...
