Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When I have to remove port security completly from a 3550 switch and re-apply security again to all ports, SOME ports that had the original mac address start being violated? even though the mac has not changed?I have used the clear port security comm...
On my test lab I have 4 routers. All running BGP + local IGP. Three routers are in the same AS 100. Sh ip bgp on all three routers show the correct networks have been learned by bgp and when you do a SH ip route, two of the routers have injected the ...
If you have say, 3 sites with their own call managers and you have emplyees who go between the sites. Can you set it up so that they have just one number, no matter which site they are on? Also can you set it up so that if they are working from hom...
AruThanks for your answer. but it does not resolve my issue. I use dynamic stick securityThe confoguration I use is-interface FastEthernet0/1 switchport access vlan @ switchport mode access switchport port-security switchport port-security violation...
I found the solution to my problem. I probably did not explain it to you properly.I had to redistribute BGP int EIGRP at the two edge routers and this showed as EX D route in the routing table of the mid router. Thanks for your time.
