Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I am encountering an issue where when using an extended ACL as the network list for a VPN policy, the destinations are not appearing in the 'Secured Routes (IPV4)' within the AnyConnect client. And therefore they are being routed outside of ...
Hi,
Hopefully this should be a simple question, but I cannot find an answer online.
Does anyone know if you can deploy a virtual ASA a Firepower 'bolt-on'? Or would you have to deploy both ASAv and a virtual Firepower appliance and route traffic ...
Hi,
This should be a really simple question but I can't find a definite answer elsewhere.
When running the command 'Redundancy reload peer' in order to reload the peer supervisor in a live firmware upgrade scenario, will the ports on the peer swi...
Hello all. My organisation has recently implemented Cisco ISE and we have come up against an issue.The issue relates to the Machine Access Restrictions option within Advanced Authentication Settings, whereby users must reboot their machines in order ...
Hi,
I'm trying to allow an internal address to access an external SFTP site on port 2022, however there seems to be an access-list denying the packets.
When I run the packet tracer, I receive the below results:
Phase: 3Type: ACCESS-LISTSubtype:Res...
Hi Andy,These are both end-of-life products, so I'm assuming you're looking to purchase these for a lab/personal environment?If you could let us know your requirements, we might be able to help with a recommendation.Daryl
Have you tried disconnecting and reconnecting the power, rather than just a CLI reload?If so, then unfortunately you have a hardware fault, and will require a replacement switch.
.png "Arumugam Muthaiah"){kind=avatar}
