Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All, I am looking to restrict per client user bandwidth for our Guest network on Cisco 9800 WLC's. AP's are in Flexconnect mode.IOS version is 17.3.5aIs this possible on catalyst WLC like Aireos based WLC's? -Kamal
Hi All, We have been recently getting notices that our webex site xyzcompany.webex.com will upgrade at the time mentioned in email. That is our production time and we would like to permanently change these upgrade times to off hours instead of manual...
Hi All,
I have added Opendns servers at my router(Unifi Dream machine). On DHCP server so that clients get correct DNS server. and then verified on computer that it is using open DNS from settings and packet captures too. However when I go online to ...
Hi All,I am planning to cover a Mezzanine area which is 300 feet long and 30 feet wide. My plan is to go for one 2800E with AIR-ANT2566P4W-R. However I have doubts regarding if adding one AP with antenna on wall facing other end of wall should be eno...
We had a power outage and somehow APs tried to join the WLC not in mobility group and then won't join back to primary or backup WLCs. Just brought mobility up between them and they joined back instantly. They were giving same "controller verification...
Please check the following:-Verify that Country on WLC code matches with the AP model number.AP is getting required power for radios to operate.802.11b/g/n and 802.11 a/n/ac are enabled under wireless.Check if AP's in proper AP group which has the re...
Make sure AP is in correct mode and All Radios are enabled(802.11a/n/ac and 802.11b/g/n).AP should be part of AP group which has SSID added to it.SSID is enabled and broadcasting.There is DHCP server available for clients to grab IP address. If not t...
