Hi I am trying to figure out how access-list work from a bgb environment using cisco 2821 flash:c2800nm-advipservicesk9-mz.124-7a.binIs it ingress or egress from the Ethernet or serial interface that access-list 6 is applied? router bgp 200 no sy...
Hello Cisco, I have a cisco 2821 running Version 12.4(6)T3, I issued a write erase and cleared off the following two certificate; crypto pki trustpoint crypto pki certificateCan someome please tell me what steps I need to take to restore both Certi...
Hello Cisco ,i have the below class-map and policy-map statments located in a cisco WS-C4506 running cat4000-i5s-m code, can you tell me what they are used for? any help would be greatly appreciated. Thank you Charlie class-map match-all cm_att_...
Hello Cisco, I support a Cisco cat switch with the following codes WS-C6509 Software, Version NmpSW: 6.3(5). My question, It seems I cannot add more then one SNMP string to this device, is this true? And if so, What If I update the set snmp commu...
Hello Everyone, I came across and message while going through my morning check list from my catalyst switches, The show environment all command, noticed an issue from a Cisco catalyst switch running Hardware Version: 2.0 Model: WS-C6509. I also ...
Narayan, That alarming, would you know where there is a link that can explain Access-list and how they are applied to a bgp system. Thank you for the quick Response. Charlie
