Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello!We have a problem with AIR-LAP1142N access points.AIR-LAP1142N-E-K9Version 12.4(21a)JALAP's are not assotiated with controller yet. They get the ip address via dhcp, they are reachable by icmp.When I try to telnet, I get Password required, but...
Hello!Periodically we are suffering a problem with L2L tunnel between 5505 and 5520Sometimes there is no access from 5505's local LAN to one of the 5520's LAN ex: ping from inside interface 5505 (10.1.13.1) to 5520 (10.1.1.1) doesn't work5505: - fr...
Hi Netpros,I'm migrating from CSS to ACE. Some of my sites are using SSL client authentication and CSS acts as SSL-terminator. Also backend servers need client certificate number (CN) to be forwarded from CSS. In this configuration I'm simply using â...
Hi all!The same problem, I have PIX with two outside interfaces and need to translate connections from my inside network hosts to different public outside addresses.I've used nat/global pairs to translate my inside host A with internal IP address 192...
Hi all!I have PIX with two virtual outside, inside and dmz interfaces.Outside 1: outside-205 - 195.1.1.10/24Outside 2: outside-500 - 220.2.2.20/24inside - 192.168.3.0/24dmz - 192.168.4.0/24My task is to translate inside hosts to 195.1.1.10 and dmz ho...
In our case, problem was in previous version of Cisco Jabber. Jabber 9.6.1 was not uninstalled correctly. Old Jabber client was successfully removed and problem is gone.
1) In general, is it normal situation for LAP 1142-N to answer "Password required, but none set" to the remote telnet session?2) Is there any dhcp option, that can inform the LAP about WLC ip address?
The thing is, that LAPs don't know, which controller they need to join to.The controller is situated in another L3 segment. I need to tell them, what controller ip is. If I reset them,will I be able to get remote access to them via telnet/ssh ?
