Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Hi, I have two Nexus 5672 switches with active FCOE protocol. They have worked without problems for several years. We are noticing some issues such as:
%NPV-5-FRAME_DISCARDED: %$VSAN 4%$ Frame with unexpected FC2 status 0xc received on interface ...
Good Morning, I wanted to ask you for information regarding the compatibility of the Nexus N7K-F312FQ-25 card with the 25Giga SFP-H25GB-SR transceiver. Is there a document/datasheet that certifies this compatibility?
Thanks!!!
Hi all,
I've two Nexus C7010 with NX-OS 6.2(10).
I have some doubts about creating vpc on two new vdc.The two nexus do not have the admin context but the default context. The vdc will then have to configure them from the default context that is c...
Hi, I've a new Cisco 7706. When I power on it it continously reboots the module 3 supervisor. I've noticed a "misconfigured" parameter during the boot:
"Reset Reason Registers: 0x40 0x0"
Normally it is 0x10 0x0....
Anyone knows how to change this ...
Hi,We have two Cisco Nexus 7710 with the following HW configurationSlot 1: N77-F348XP-23Slot 2: N77--F248XP-23ESlot 5: N77-SUP2E When I try to create a LACP portchannel with one port on F3 and another port on F2e I receive this error (when i try to b...
I've done a debug on the vsan and I receive this output (a part...)
2024 Mar 14 13:14:07.637812 npv: Failed to send NS request on vsan 4 - Connection refused 2024 Mar 14 13:14:07.697768 npv: Failed to send NS request on vsan 4 - Connection refused 20...
It says..."With Cisco NX-OS Release 6.2(6), you cannot interoperate the F3 Series plus the F2 and/or F2e Series plus the M2 Series modules in the same VDC." If I've understood well...is not possible to do a LACP etherchannel on two different modules....
Tnx a lot for your answer. I understand now what you told me. But in my case I need to give READ accesss for all comands for users in a specified group. I'm not able to do this task. With predefinied group I don't have this opportunity and my custome...
Ok, it is not 100% clearly.I've added this statemet on the ASRtaskgroup NetworkViewer task read acl task read bgp task read basic-services!usergroup NetworkViewer taskgroup NetworkViewer!but I didn't understand what I have to do on the ACS
