Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I've two Nexus C7010 with NX-OS 6.2(10).
I have some doubts about creating vpc on two new vdc.The two nexus do not have the admin context but the default context. The vdc will then have to configure them from the default context that is c...
Hi, I've a new Cisco 7706. When I power on it it continously reboots the module 3 supervisor. I've noticed a "misconfigured" parameter during the boot:
"Reset Reason Registers: 0x40 0x0"
Normally it is 0x10 0x0....
Anyone knows how to change this ...
Hi,We have two Cisco Nexus 7710 with the following HW configurationSlot 1: N77-F348XP-23Slot 2: N77--F248XP-23ESlot 5: N77-SUP2E When I try to create a LACP portchannel with one port on F3 and another port on F2e I receive this error (when i try to b...
Hi,I've configured two Cisco ASR 9006 with IOS XR 4.3.0 with the aaa. I've a problem with the authorization statement.I need to distiguish two groups.Network Administrator (Full access, show, configuration etc etc)Network Viewer (Users in this group ...
Hi,we have an issue with eap-tls authentication with SAN (Subject Alternate Name). The authentication uses the CN instead of SAN. Our enviroment is so build:1 LWAPP Cisco AP1 WLC & 1 WCS1 ACS (4.2.(1) Build 15 Patch 3)1 CA (Certification Authority en...
It says..."With Cisco NX-OS Release 6.2(6), you cannot interoperate the F3 Series plus the F2 and/or F2e Series plus the M2 Series modules in the same VDC." If I've understood well...is not possible to do a LACP etherchannel on two different modules....
Tnx a lot for your answer. I understand now what you told me. But in my case I need to give READ accesss for all comands for users in a specified group. I'm not able to do this task. With predefinied group I don't have this opportunity and my custome...
Ok, it is not 100% clearly.I've added this statemet on the ASRtaskgroup NetworkViewer task read acl task read bgp task read basic-services!usergroup NetworkViewer taskgroup NetworkViewer!but I didn't understand what I have to do on the ACS
