Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following on my switch (cat 6500 running IOS)console:switch_01 con0 is now availablePress RETURN to get started.When I press RETURN, I see the same message again and again, but do not see the prompt. I tried to change the config-register f...
Hi all,I have the following config: IOS ver 12.2 on cat6500 sup720 running native IOS!username roadrunner privilege 15 password xxxaaa new-modelaaa authentication login default group tacacs+ localaaa authentication login console localaaa authenticati...
Dear all, We have voIP between two sites, connected over MPLS and voice calls drop now and then. We use Avaya for Voice boxes and Cisco routers/switches elsewhere. QoS is configured on both ends of the MPLS to prioritize voice packets and I do not se...
Dear all,We have voIP between two sites, connected over MPLS and voice calls drop now and then. We use Avaya for Voice boxes and Cisco routers/switches elsewhere. QoS is configured on both ends of the MPLS to prioritize voice packets and I do not see...
Hi,My understanding of VPN 3000 Concentrator is as below:1. VPN3000 will not negotiate IKE proposals if it is the initiator of the tunnel. The remote end has to have the exact IKE parameters. But if VPN3000 is the responder, it will agree to negotiat...
Hi all,I solved this. I was on the wrong rommon. I was at the switch rommon. I pressed ctrl-Break too early and landed up on the Switch Processor. But, what was needed is the Route Processor rommon. I waited till the control was passed on to the RP a...
Thanks Prem. That was exactly my understanding too. For now, I have skipped the enable password checking on the console with the "privilege-level 15" under line con 0. This directly puts me in the privilege exec mode.The bottom line is, the console m...
Hello Guys,First, thank you all for looking at my post and responding. After going over your responses, I feel that my initial post is a bit unclear of the requirements. I myself realized this only after reading your posts.Coming to the issue, I have...
Thank you Martin. I read and understood the same from the MPLS and VPN book later.Thank you for your time.But my first question is still unanswered.Thank you,Mohan
