Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi I am adding a more specific dial-peer to point outbound calls to a new provider (Teams Direct) however all out bound calls match the original 9.T dial peer for example, sho dial plan matches correct dial peer but debugs and SIP messaging shows cal...
Hi
I have an ESXi host with 10G fibre uplinks to 2 x Nexus 5598 both Nexus are configured identical and associated ports/VPC show up.
Ports/VPC are configured as access port and all looks well, however I am trying to understand the Bandwidth of the ...
HiI have a cordless phone connected to a FXS and it is registered with CUCM 8.6 using STCAPP config which all works well.However the user would like to transfer calls from the Cordless Phone to internall IP Phones.Features have been enabled on the Ga...
Hi We have recently installed a SPA232D and integrated with our CUCM 8.5 as a 3rd party SIP devices which works fine.However approx every 3 days the device unregisters from CUCM and only way to bring it back up is a reboot.When it is deregistered we ...
We are currently running HSRP in our core with 2 devices within 1 HSRP Group which is fine.We have an adjacent building where all hosts use this HSRP instance as their Gateway which works fine.However we have an issue in that SRST is failing in remot...
Hi AlexLooking at spec it does not say either or only says R Button = flash.I will ask the site to get a phone which has TB/EG selectable to test and we can set to TIME BREAK and test again.Thanks
Correct no Dial Tone Heard, I am pretty sure R key (hookflash) is hitting the Gateway from the debug, perhaps someone can confirm.To be sure I changed the hookflash settings so threshold was smaller than phone hookflash so FXS set to 200 - 50 and ph...
