About svibeesh85

svibeesh85 · 02-04-2014

We are positioning the nexus 7K pair as the core switch. We are creating VDC and configuring VPC. Since we are creating VPC we are making the pair act as a single switch. Would it be ok to place only one supervisor per 7K. Eventually the one logical...

svibeesh85 · 09-30-2013

Ok, Lets go through this. Can you please confirm if you have enabled multicasting and IGMP snooping in WLC.Are your AP in multicast mode.What multicast group traffic do you see on your WLC.

svibeesh85 · 04-17-2013

Am intrigued !! what is that your end goal ?

svibeesh85 · 04-17-2013

No worries mate !!Ensure all the power modules are in place and proper fixedEnsure you SUP is in place properlyEnsure the Flash with the required IOS is in place and is not corrupt.Boot it up !!I think you will hit the boot os, from there you need ...

svibeesh85 · 04-17-2013

Mate check the ip addressing for te mgmt vlan. Along with the mask. Unable to ping within the mgmt vlan needs to be checked out. Chek if the uplink is allowin the mgmt vlan

svibeesh85 · 04-17-2013

Mate, Do your employees hot desk or do they have designated seats ?A min of 10% extra should always be considered. But again you need to understand at what rate you are expected to grow.In short 10-15% is a minimum you should be looking at.

Member Since	‎03-24-2011 03:17 AM
Date Last Visited	‎08-18-2017 03:56 AM
Posts	17

User Statistics

User Activity

Supervisor Module per Nexus7K

Cisco WLC 5508 & HP Printer

Re: Question about LACP distance restriction

Starting 6509 from scratch

Nexus inband management with SVI

percentage of the spare network points to the activated ones