HI all, Can you please advise if MPLS Carrier Supporting Carrier feature supported in the following platform?  * ISR4000 series * ASR1000 series * ASR903 router Search through Cisco website cannot find confirmed answer. Thanks ... View more

Hi all, I am planning to install GSR 12404 router for Internet router to receive full BGP routing table. Just wondering what the maximum routes supported for GSR into the CEF? The hardware will be used is as below PRP-2 SIP-400 w/ SPA-2x1GE Thanks, ... View more

Hi all, I am considering to setup LACP between two different sites via E-LINE service, just wondering if there is any distance restriction on this? Or is there any special configuration I need to do on LACP to overcome delay caused by the long distance? Thanks ... View more

Hi all, I have a question for Y.1731 one-way delay, one-way-delay variance measurement in ASR9K. From the configuration guide document, it says that in order to monitor the one-way metrics, there must be valid DTI input into RSP card on ASR9K router at both ends (details below). I am wondering if there is any other alternative like deriving time from PTPv2? It is less likely to have DTI connection for all the routers. To configure one-way delay measurements, be sure that the following clocking prerequisites are met: •Frequency synchronization is configured globally in its default line timing mode (The clock-interface timing mode command is not configured.) •The clock interface (Sync 0 / Sync 1) on the RSP is configured as a DTI port using the port-parameters dti command. •Valid DTI input signals are available for the RSP clock-interface ports. •Both Local and remote routers are using DTI timing input signals. http://www.cisco.com/en/US/docs/routers/asr9000/software/asr9k_r4.2/interfaces/configuration/guide/hc42eoam.html#wp1040522 Thanks ... View more