Hi,
Please help me to understand if in a network scenario where AAAA records and A records in registered in public DNS . So in this scenario whether DNS64 along with NAT64 needs to used for IPv6 translation approach or enabling only NAT64 feature on ...
Dear Team, I am having two cisco ASA 5510 firewall with existing firmware as asa825-k8.bin (8.2(5)). I need to upgrade the firmware to the latest version. As I gone through the cisco documents, CISCO recommends that minimum 1 GB RAM is required to up...
Dear Team, I have 2 nos of Cisco 2504 WLC configured with 1 SSID each configured with different network address in same LAN. Cisco 2504 is connected to Cisco 2960 L2 switch--->Cisco 3850 L3 switch----->Cisco ASA firewalll--->Cisco 2951 router----> in...
Hi, Is this part code WS-C4506-E | "Cat4500 E-Series 6-Slot Chassis, fan, no ps" covered under LLW option. And is this part shipped from India Depot in case it it supported under LLW option. Regards,Manoj
Hi all ,I want to import CISCO-UNIFIED-COMPUTING-COMPUTE-MIB.my file into my cisco LMS 3.2 .I have already downloaded the MIB from cisco.com . I need to know whether any supporting MIB is required for uploading the abobe mentioned MIB . I need to upl...
Hi Jim,
Thanks for the useful information .
With reference to above information . If suppose i have AAAA records for applications registered in Public DNS so in this case the traffic from IPv6 client trying to access legacy applications running on I...
Thankyou very much for your valuable feedback!!!IF i will shutdown the Active firewall of DC and Make standby DR firewall as active . SO when i will power on the Active Firewall of DC will it take the standby state or it will come up with Active stat...
Thankyou for your feedback !!I am running Software Version 8.2(1) , Hardware: ASA5510, 256 MB RAM, CPU Pentium 4 Celeron 1600 MHz Internal ATA Compact Flash, 256MB . I have configured ipsec vpn with 12 profile in active state . But at a particular...
Hi Leo,Thanks for your response.Client laptop trying to connect the SSID and once authentication key entered ,it will try for a while then error message come "could not connect...." As our suggested,i will create new profile with open authentication,...
