Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My customer is interested in upgrading from 8.0.135 to 8.0.140. Checking the release notes, CSCue51812 (band select problems is listed as open,but the bug detail info shows it as fixed in 7.2. Is this a typo, or did the bug re-emerge? Band select...
Is there any information available on what might cause an Edge 340 to go into sleep or soft off mode, and how to recover them, short of power cycling? thank you
My customer is implmenting an AT&T 10 GB UVN connection for data center replication. Their architecture calls for ASR routers to terminate these connections, but, due to the cost of 10GB on the ASR, they want to look at connecting one end directly t...
Customer running Nexus 7000 6.03a. Core and Distribution VDCs. With the static RP configuration shown below,a source in VLAN 300 attached to a L2 Catalyst 6500, and a receiver on eth 1/14 on the core, multicast trafficin groups 234.5.6.7-234.5.6.11...
Xander,As I cannot view the bug report CSCuo98956, it's restricted to Cisco, can you tell me if there is an ETA/release level set for it? It appears to be a pre-req for any TOD or QOS ACL, if I read your comments correctly.Also, we have determined t...
Xander, I think we can go with EEM for the TOD, thanks. Just one last question - the acls are used in QOS policy. I assume the service policies will react the acl changes - i.e., they don't do any sort of pre-compilation or similar?I'll need to res...
Xander, thanks again for quick response. I should explain that our customer is enterprise, not SP. They currently have ASR 1006, and are migrating to 9006 for 40GB capacity in their new data center. That being the case, the BNG option for TOD acl...
