Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi All,
I'm having a battle with NAT between VRF's.. Basically, we have VRF's that have customer prefixes only, plus a default route from a transit router in the global table. Customers NAT to everything that isn't in their VRF.
Everything works fla...
Is ErrDisable missing entirely on this platform?
Given it is available on the rest of the ME-platform, any idea when we can expect this (really basic) functionality??? Seems storm control (and various other L2 security/reliability functions) can sh...
Hi Guys,So I have a problem with VRF's on a CSR 1000V, specifically exporting a connected subnet from a VRF into the global routing table.My config, very abbreviated, is as follows:Router:GE1: 10.0.0.1/31 VRF TESTGE2: 172.30.20.1/24 (No VRF, BGP neig...
This is quick and dirty, but I couldn't find anything out there with the functionality I needed. I basically wanted to be able to issue commands to manually reset a buggy LTE interface on a C2911 (EHWIC-LTE-4G-G) as it crashes every week. I had an EE...
I've just lodged a service request for this, but as I don't have a service contract I'm not sure how much support I will get from Cisco vs them just replacing the whole unit..In any case, It's a LFF C240 M3, dual CPU. It was purchased with an LSI2008...
If anyone else has C220's be very careful remotely updating the HUU as I am 100% convinced the HUU is killing power supplies. Just had this today going from quite an old revision (~2.x) to 4.0(2f) on 2 x C220-M4's Both had one of the 2 PSU's killed b...
We had a few 819's with the Sierra Wireless 7710's in them (Check the sticker on the base of the unit).
I had to write an EEM script to remote-reboot them when the modem locked up. It is hands down the worst Cisco products we have ever purchased. At...
If you use the same config everywhere, but it doesn't work at one site I would start by removing the individual commands you have added until connectivity returns, then you will know what command has caused your connectivity problem.
What you say "lo...
Yep, so on your platform you are license limited to 50mbit or 100mbit - however the router itself is far more powerful than that. Unless there is an error condition you will never enable so many features that you "overload" your router - Your limit i...
