Hello, I'm currently meet an issue with a VPN IKEv2. Actually I have 2 local subnets (10.10.0.0/16 & 192.168.90.0/24) that want to reach a remote subnet (10.20.0.0/16). Here my access-list:access-list ACL_REMOTE line 1 extended permit ip 10.10.0.0 2...
Hello,
I just need some confirmation about compatibility between 2 models that support Mobility Express.
Is it possible to manage AP1542I-E-K9 and AIR-AP1832I-E-K9C with Mobility Express on the same network? Is it a problem that I have 2 differents...
Dear all,
I tried to enable flow-control on my interface but from a "show interface" it show me that is not supported.
Here my configuration :
interface GigabitEthernet1/0/48 switchport access vlan 51 switchport mode access flowcontrol receive on...
Hi,
I'm actually faced to a strange problem, I tried to connect a old firewall Cisco ASA 5510 (in transparent mode) to a Nexus 5572UP but when I do that I have many packet loss.
Can someone help me ?
Thanks!
Dear all,
Actually I've connected two switches 5672UP using 40G ports. SFPs are recognizing but from a "show interface eth2/5" indicates no any cable is connected (Ethernet2/5 is down (Link not connected)). I tried to break into four 10G connection...
I think you are right,check the document:
https://www.cisco.com/c/en/us/td/docs/wireless/compatibility/matrix/compatibility-matrix.html#pgfId-308874
Finaly ,are you sure that I can mixed AP1542I-E-K9 and AIR-AP1832I-E-K9C on the same network and ma...
Hello patoberli,
On this documents it seem's AP1542I-E-K9 does not support Mobility express, but from the link below indicate the opposite:
https://www.cisco.com/c/en/us/td/docs/wireless/access_point/1540/installation/guide/1540hig/ch1.html
whic...
Just for your information, according Cisco page "Cisco feature Navigator"flowcontrol is supported on version 16.6.1 but in reality is not supported because after upgrade our switches flowcontrol it seem's not activated.
Thank you Cisco