Hi,
I'm trying to find better documentation that describes the differences between VDCs in IOS and NX-OS. So far, this is the best I can find:
http://docwiki.cisco.com/wiki/Cisco_NX-OS/IOS_Layer-3_Virtualization_Comparison
The key question is the n...
Hi,Is JTAPI pretty much the way to go to interface with CUCM for a CTI application? It looks solid, but I want to be sure that I'm not overlooking a better option.Thanks,David
Has anyone noticed any physical problems with the management interface on the ASR line (1002 in particular)?We move the cable just a small amount, and the link light goes out.Logical config/setup is correct. We've burned through a pile of cables, sa...
Does anyone know where the correct contents of the document titled "Cisco Unity: Voice Mail Stops After 30 Seconds" is?The document with that title at this location:http://www.cisco.com/en/US/partner/products/sw/voicesw/ps2237/products_tech_note09186...
I'm just trying to enter the IOS commands on this page:
http://docwiki.cisco.com/wiki/Cisco_NX-OS/IOS_Layer-3_Virtualization_Comparison
The NX-OS works fine, but IOS does not let you create the address-family in BGP without configuring an RD in the...
Hi Peter,
Thanks for the reply.
I agree that RDs are required to handle overlapping addresses in a single BGP process/table. If you spin up a new BGP process, table or some other construct for each VRF, however, the overlapping address problem goes...
Hi Jeff,The contents of that pdf seems to deal with delay sources in using unity, not with voicemail that simply stops after 30 seconds.If I recall, the document with this pdf's title used to address an mgcp gateway keepalive issue. Unity does not s...
