Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I have the following challange.I deployed Cisco vWLC 7.5.102.0 and joined two AP Cisco 2602E which I successfully converted from AP to LAP. Both APs joined vWLC, enabled and show "operational status" REG. On vWLC I enabled broadcast SSID, c...
Hello All,I configured Cisco 2921 as SRST router and H323 gateway. My phones (Cisco 8961) are registered.I cannot call in from PSTN and pickup the call, but for some reason I cannot dial any extension or PSTN number.Config and show commands in attach...
Hello All,I have Cisco UC500 as voice gateway for Cisco CUCM. I need to block a few incoming numbers based on calling number. I have FXO voice ports with connection plar to 588 and VOIP dial peer with destination patter 5.. (to CUCM extensions). When...
Hello everybody,I have two Cisco UCM in two different locations, intercluster trunk between them through VPN. Each location has voice gateway on Cisco ISR.I simulate this scenario. User from Location 1 is calling to user from Location 2. In case if u...
Hi, Novri,No, I added bind all source-interface ge0/0But currently I have only one physical interface and IP (I replaced trunk by access).This interface has connandsh323-gateway voip interfaceh323-gateway voip bind srcaddr 10.13.206.2So, use one int...
Hi Sree,Sure I'll give you more details. Phone shows SRST MODE system message.When I dial any number (extension or Pstn) looks like a phone waits for digits, but after luke 10 seconds it sound like fast busy tone (if I am not wrong it's reorder tone ...
Hello Michael ,Thanks for reply. As far as I understood this answer-address is used to match a dial-peer.My problem is that incoming call matches a particular dial-peer but translation rule that I applied to this dial-peer does not reject a call for ...
