Good day everyone!device: MSFC2(C6MSFC2-BOOT-M), Version 2.1(8a)EX.A_Root(config)#interface Vlan 15A_Root(config-if)#ip route-cache flowQ: When I do 'show ip cache flow', only 1 packet per IP is printed(see attached file).thank you very much.
HI, Why the VPN session between PIX and Windows Server is disconnected every 5400s, even the traffic is still active. I have verified there is no such a lifetime in these devices.What could be the problem?Thanks a lot.
Hi all,PSTN-PBX1-bri-Cisco-WAN-Cisco-bri-PBX2-ph2(882)|..............||..............|out3 ph1(881)#. The ph1 connecterd to PBX1 is redirected all ouside calls to ph2.when I type show isdn active: Calling Called Number Number-----------...
Hi all,PSTN-PBX-bri-Cisco-WAN-Cisco-bri-PBX-ph2(882)|..............||..............|outph3 ph1(881)#. The phone1 is redirected all ouside calls to phone2.when I type show isdn active: Calling Called Number Number------------------------...
When I do configure netflow export destinations for both parts, it works., the problem is that all traffic is exported, not only traffic from Vlan 15., but it's OK, thank you very much for the support.
On MSFC:interface Vlan15 ip address x.x.x.x ip route-cache flowip flow-export source Vlan15ip flow-export version 5ip flow-export destination 10.248.6.70 9994On Catalyst:#mlsset mls flow fullset mls agingtime 128set mls nde enable### I suppose this v...
MLS is already enabled, because only the first packet is routed through the MSFC, the remaining packets are switched on the Supervisor.on switch:#mlsset mls flow fullset mls nde enableMLS commands supported on MSFC:A_Root(config)#mls ? ip ip keywor...