Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I have a problem with a CiscoWorks server. If I perform a "Device Discovery", the server discovers several devices but I can not see them in the inventory dashboard. However, when I restart all the CiscoWorks services, the Inventory dashboard s...
Hello,A customer of us has a issue with an e-mail server. It's trying to do a DNS reverse lookup of its private IP address, but It doesn't find it in the DNS server:192.168.100.9 (Reverse lookup) - error could not reverse lookup 192.168.100.9 in DNS:...
Hello,I want to route all traffic received from a subnet (for example, 192.168.10.0/24) through a particular interface (FastEthernet0/1). For this reason, I've implemented a route map with "set ip next-hop":interface FastEthernet0/0 ip address 192.16...
Hello,I have to install a PIX firewall and I have a question. Our ISP has assigned us two ranges of IP's (each range from a different subnet, for example, 10.165.100.32/27 and 10.165.200.160/27). I will assign one IP from one of these two ranges to t...
Hello,In the following data sheet:http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/vcallcon/ps10030/ps10031/data_sheet_c78-504126.htmlI've read that the SPA9000 has one FXO port. Is this device a PSTN to VoIP gateway? or It needs a SPA400 to...
Hello John,Thanks for the info. I was able to see this report:Device Discovery Summary Discovery Status:Completed Discovery Start Time:Wed Jul 20 13:33:09 CEST 2011 Discovery End Time:Wed Jul 20 13:33:25 CEST 2011 Total Devices Discovered:3 Reac...
Hello Michael, Did you resolve the problem? The command syntax seems OK. Did you try to debug the file transfer with "debug ip ftp"? Best regards,César.
Hello Steve,I think you could assign the SSID (to which the PC connects) to the VLAN 2. And then, create a trunk between the switch and the AP.interface FastEthernetX/Y switchport mode trunk switchport trunk encapsulation dot1qAnother option, if yo...
A simple example of flexlink is: Switch# configure terminalSwitch(conf)# interface gigabitethernet0/1Switch(conf-if)# switchport backup interface gigabitethernet0/2Switch(conf-if)# endIn this case, when the gigabitethernet01 (the active link) goes do...
Hello,You can use the copper SFP + media converter or the F.O SFP without media converter. I.E.:3560 - SFP (1000BASE-T) ---------- Media converter ------ F.O.------ Media converter ------- Cisco 5003560 - SFP (1000BASE-LX or SX) ---------- F.O. -----...
