Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everybody,I would like to know the best way to extend the life of spare equipment, like routers, switches or APs.Which is better, keep them connected to the network without configuration and configure them if necessary, or save them off and s...
Hello everybody,I want to know how to storage the DHCP IP table in a external flash of a router. This is because the router is switched off and switched on everyday but I want that it remembers which MAC is associated with which IP when it starts aga...
Hello everybody,I want to use Cisco Embedded Event Manager in a router for monitoring a DNS entry that normally resolves 1.1.1.1 but if it changes to 2.2.2.2 the router has to change some access list automatically in order to permit different rou...
Hi mate,
You may want to check the log. I got the same message because the following reason:
Feb 13 08:36:15.559: Error: CLI 'interface output physical snmp' not valid in 'input' directionFeb 13 08:36:36.160: Error: CLI 'interface input physical sn...
Almost forguet!The command ip dhcp database flash:/xxxx will save the DHCP table into the internal flash or intro the external flash (the extraible card)??Thanks!
Thank you so much Alain!What do you mean with disable coflict logging? I think that is just information for troubleshooting. How can disable it help me?Thank you again in advance. Your information is very appreciated.Marcos.
