Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
Couple of weeks ago we have Installed some new AP2800i is our organization network and we did upgrade WLC 5508 software from 8.2.151 to 8.3.122 in which Cisco recommended.
Do I need to upgrade software again???
Please find information about...
Hi,
My Company is going for Cisco Prime. Can anybody help me if Cisco PI 3.1 support SNMP monitoring for non-Cisco devices listed below?
There are couple of Fortinet devices, Netscaler, IBM switch and Zeatron devices.
Thanks,
Hi,
My Company is going for Cisco Prime Infrastructure 3.3 (Virtual image). I am charging for ordering, Design, installation and management.
My question is:
1- What is requirement for installation? (not hardware specification)
2- Do we need SQL se...
Currently there are three stacked WS-C3750G-24TS-1U on data centre. I am going to buy a WS-C3560X-48T-L to use 10GbE module. Is it possible stack this switch "WS-C3560X-48T-L" to current switches "WS-C3750G-24TS-1U" ?
I have a document says Cisco PI 3.1 discover SNMP devices and you can upload MIBs as well. What does it mean?
-----------------------------------
Monitoring Third-Party Devices By Polling MIBs
You can design custom MIB polling policies to monitor thi...
