Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
We have a WLC connected to the CORE switch directly and I'm just wondering if it's required to configure DAI on the CORE switch, since all the users' traffic is tunneled to the WLC, I tried to check that in the configurations best practi...
Hi,
I'm using WLC 9800 local switching mode, I can see all the wifi client devices MAC coming from WLC ports (since the traffic is tunneled to the WLC), at the same time I'm configuring DHCP snooping in the Core switch to avoid any DHCP rogue servers...
Hi everyone,
I noticed in new deployment 9800-L deployment, that a lot of Access points stop randomly broadcasting SSIDs.
I analyzed the config by using the Wireless Config Analyzer tool, and noticed :
RF: WLC has 84.6% of APs with failed Interferen...
Hello,
As said in the title, I'm looking for redirecting traffic directly to the firewall instead of getting it inspected,
I'm trying to understand proxy functioning in the actual setup, still not sure of my understanding and want to have your input ...
Hello,
I'm a bit confused regarding the correct implementation of DAI, I've read somewhere that the DHCP snooping binding table should be populated first before activating DAI, and it always work good like that, but what about new devices/users ? whe...
Hi Ruan,
I fixed this back then by upgrading to another release (even though it was the recommended one I was using, it was affected too).
I switched all the APs to Client mode manually instead of automatic in the meantime. But the upgrade if I remem...
Thank you for your reply,I mean by the whole network went down, no client was receiving IP from the DHCP, the uplink towards it was trusted obviously.
Disabling DAI didn't fix the issue, I had to reboot the Core switch so the clients can acquire IPs ...
As i'm reading the Best practices shared, I see that 9800 has built-in DHCP Snooping feature. I didn't find it anywhere in the settings "Cisco IOS XE has embedded security features such as Dynamic Host Configuration Protocol (DHCP) snooping"
Since al...
