I was trying to do a password recovery on a 1142 AP but enable password did not reset and I am stuck AP model is AIR-AP1142N-A-K9Running IOS c1140-k9w7-mx.124-21a.JA1Its autonomous so there is no controller. Any direction would be appreciate...
I am trying to configure port 8 on the WLC 5508 to a dsl line that connects to a linksys switch. This is seperate from primary port which is configured as LAG and has the rest of the vlans. I am not sure how best to achieve this.
WLC 5508 as anchor running 7.0.116.0 locally configured DHCP scope. Scope has been enabled. There are 2 Foreign controllers in different locations Mobility ggroups have been configured and there is communication between them I am able to ping ,...
I am installing a new 5508 controller and i have a management interface mapped to port 1 and serveral wlans also tied to port 1. Port 1 is trunked to the Core switch. I am able to ping the wlans from the core and ping their default gateways ...
I am unable to get into the GUI. Running CUE 2.3 on a 2821 running IOS version 12.4(11)T. I accessed the cli and changed the web admin password have reloaded the module and reloaded the router but still no dice.
Thanks for your response Scott but I did that with no luck I just formatted the flash (overkill I think)and I am tftping a new image to see if that helps