Use of the "no service password-recovery" command is recommended when hardening Cisco-devices.But as I see the command is not available on the IE-platform? In my case: IE3300 running IOS XE 16.12.03 (Gibraltar) What would be the correct command to pr...
I do have a ASR 920 that is stuck in Freq_locked state, (it does not reach Phase_aligned), do anyone know of any useful debug commands that is able to show why it does not reach Phase_aligned?
Does anyone know if NCS5501 support config backup via SNMP/TFTP?
I am trying to backup the device, but with no luck...
From debug snmp request:
snmpd[1001]: t6812 DO-SET: [0] OID:1.3.6.1.4.1.9.2.1.55.XXX.YYY.ZZZ.11
snmpd[1001]: t6812 DO-SET: [0] ob...
Blindly following the "recommended" best practice? Think about this: What happens if there is a disgruntled employee who, before getting escorted out, turns this feature on and then scrambles the password.Just think about it. Well... the use of no...
Sorry, that was not what I ment.
MGMT-ROUTER and MGMT-SWITCH is not connected through the mgmt-interface, but by regular interfaces with a trunk (vlan 51). Each interface (except uplink) on MGMT-SWITCH are then part of vlan 51 as access ports. The ...
.jpg "VIP Community Legend"){kind=icon}
