Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,
We have one MX800 and one MX300 in our office. Both of them connect to our another office by a leasing line. And we are using Cisco IP phone 7841 for each staff. The phone system is managed by Cisco BE6000. But the Video system is not managed b...
Hi, all,
We are using AP 1832 in our office. I test the signal strength by some mobile app. When my mobile phone is much closed to the AP, the best signal is only 23 dBm, is it normal or too weak?
If I do the same test in home, a cheap AP, the stren...
Hi all,
In our meeting room, we have bought MX800 and IP phone 8831. They would be managed by BE6000 which is in our data center.
Now the question is when we have 2 parts Video conference, some third parts want to join the meeting by telephoney syste...
Hi,
Please check the attached image. We'd like to build cupboard around the MX800 for our meeting room.
The questions is, we will setup the cupboard firstly, and then whether it is possible to install the MX800. There will be not too much space aro...
Hi,
We are going to buy Cisco MX800 single screen VC for our new meeting room. The meeting room is 9.6m * 5.6m. So, some questions here:
1. Do we need to put extra small loudspeakers on the ceiling?
2. Do we need to buy extra amplifier for the louds...
Thank a lot for your answer.
My question is 1mm to AP 1832, the RSSI is only -23dMb. But for my home AP, it could reach to -10dMb
Could I change the AP signal better?
Thanks
Thank Patrick. I should explain more details.
1. We do not have the SX80. only the MX800.
2. The MX800 will be mounted on the wall.
3. All cables will be connected from the red square to the table. You can find the red square in the attached image.
...
Hi Patrick,
Thanks a lot for your answer. Could you confirm that for such meeting room, we do not need extra speaker. The size is : 9.6m * 5.6m.
Thanks in advance.
