Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,is there a enabled "HREAP Local Switching: and enabled option "Learn Client ip address" on WLC can be a problem for static ip addresses on client?we have problem with wireless connection for Android devicesPoint is that we must have static IP a...
I need to configure ISE like RADIUS server on wireless controller with software version 7.0.252.0. On that WLC we have enabled HREAP . When i try to change NAC state to RADIUS NAC, there is notification that i must disable HREAP. But that we need on...
Hello, i have setup Radius 802.1x authentication for wireless users( secure network) on Cisco ISE. Wireless clients are connected and i see them on ISE like active endpoints.The problem is , i can not see in RADIUS live logs for success connections....
Hello. i have two routers ISR 4331, and on smart account i have two licenses ISR_4331_SecurityCan i register devices on classic way with call-home, or must wit specific license reservation? Best regards
Hello, we have Cisco Switch IE-3200 that was connected to Cisco 3550 switch .In period about every 7 days there is a problem on port on Cisco 3550 switch ,where is connected IE-3200, UDLD disable port, port goes to err-disable state:UDLD disabled int...
When we set client to DHCP, then works fine, with occasional signal loss, and after that client returns on the network, but with settings with static IP address client can not return on network, we must back settings to DHCP. Regards
Thanks everyone for suggestions.Problem was in settings for Radius protocols , Client suppression for failed attempts was enabled. After disable it, i can see authentications logs and sessions in Radius live logs.We left Client suppressions for succe...
I did not find answer in the document. From routers . i have got alarm : %SMART_LIC-4-RESERVE_IN_PROGRESS: None License Reservation process must be completed with the 'license smart reservation install' command. Reservation started on May 26 10:19:54...
Hi, Balaji,yes, we have tried to resolve the problem by replacing optics, but we were confused why is everything ok after restarting switch.In CPU Load we do not see nothing unusual. We tried with command -err-disable recovery cause udld, but did not...
