About benweber

benweber · 09-11-2023

Does anyone know if you can enable web management on the G0/0 management interface on a 9200? It's in the management vrf and routing is correct. I can ping and SSH to it from the same server I'm trying to connect to the the web interface from but i...

benweber · 04-03-2023

Has anyone else seen this? I've been upgrading a bunch of ISR routers for a client from a 16 code to 17.3.5. Pretty standard: upload the code to flash, verify it, change the boot variable, and set it to reboot over night. Done it a thousand times....

benweber · 06-07-2022

I have a customer with three 9200l switches. For management we connect to each switch via its G0/0 management port. (The switches are configured as layer-2 only so this is the only management access.) The configuration is very simple. Here's one as...

benweber · 12-22-2016

I’m wondering if anyone knows of a way to do this: I have a customer’s ASA firewall that has two ISP connections; a primary and a backup. I have the default gateway tied to an SLA track that monitors the 8.8.8.8 address, keeping the gateway pointed t...

benweber · 05-26-2016

I’m wondering if anyone can help me better understand the default NAT behavior on ASAs running 9.2 codes (specifically 9.2(4)10 in this case).I’m in the process of re-writing the config on an ASA that’s in transparent mode, going to routed mode. So I...

benweber · 09-11-2023

No response. It just spins. That's consistent with 443 not showing up on the port scan. It's not listening on either 80 or 443

benweber · 09-11-2023

I've got a case open with the TAC. I'll post back what we find. They've indicated that it works but so far nothing they've had me do has made a difference. I pointed NMAP at it and the only thing that comes back is the tcp/22 port I use to SSH to ...

benweber · 09-11-2023

Right. But that's what I mean it's inconclusive. It doesn't say that's a complete list of services supported on the management interface. I've found other Cisco documentation that indicates web management is available on the management interface b...

benweber · 04-04-2023

I confirmed through a colleague that the newer ISR codes like this one have the SD WAN code embeded in them so it's possible to boot into controller mode with this software version.

benweber · 04-04-2023

It's the isr4400-universalk9.17.03.05.SPA.bin code. I had that same thought. But I went and looked at the naming convention of the SD WAN codes and they are sufficiently different that there's no way I wouldn't have noticed, especially since I had r...

Member Since	‎07-24-2007 05:50 AM
Date Last Visited	‎04-19-2024 12:05 AM
Posts	40
Total Helpful Votes Received	36

User Statistics

User Activity

Web Management on 9200 G0/0 Management Port?

4431 Router Booted into SD WAN Mode When I Updated the Code

Intermittent Connectivity on 9200l Management Ports

Tying a Route to Multiple Tracked Addresses. Possible?

Default Translation Behavior on ASA Firewall

Re: Web Management on 9200 G0/0 Management Port?

Re: Web Management on 9200 G0/0 Management Port?

Re: Web Management on 9200 G0/0 Management Port?

Re: 4431 Router Booted into SD WAN Mode When I Updated the Code

Re: 4431 Router Booted into SD WAN Mode When I Updated the Code