Hi team, It is possible to configure a WLC 5508 as the primary controller and a WLC 5670 as secondary? Best regards Jose ... View more

Hi everybody I have a CME and I configured a trunk group -Label-, I apply the lpcor outgoing XXXX command under the trunk group but when I reload the router, the Lpcor outgoing command is missed, cheking in the startup-config is still there but not in the running-config. trunk group PSTNLD hunt-scheme random trunk group lpcor outgoing Block ! ! trunk group PSTN01800X hunt-scheme sequential trunk group lpcor outgoing Block System image file is "flash:c2900-universalk9-mz.SPA.152-2.T1.bin" Cisco CISCO2921/K9 best regards Jose ... View more

Hi Everybody I have the following architecture: | PSTN | Cellular-Line <--------> FXO (CME) <- - - - - -> CUE (Welcome Menu) <- - - -> Extension When I call from the PSTN to the Cellular line, the call is forwarded to the Autoattendat services, a welcome prompt is played, when I put the extension where I want to reach, It does not tranfer. But when I call from the PSTN to a local line It works! | PSTN | Local-Line <- - - - - - > FXO (CME) <- - - - -  -> CUE (Welcome Menu) < - - - - - -> Extension The voice-port 0/3/1 has the Cellular line connected. Best regards Jose ... View more

Hi Everybody, I have a CME with Lpcor enabled, I connected an ATA187 with two lines configured , when I enable the lpcor feature  under the voice register pool, it does not work (lpcor incoming XXXXX). Is the LPCOR feature supported for these kind of devices? Thanks Jose ... View more

Hi Everybody, I would like to know if the VAS and Intelligent traffic mirroring features,    support  encapsulation protocols like Vlans and MPLS, and how does it work? Best regards Jose ... View more

Hi everybody, I have configured the  extension mobility  feature on my CME 8.8, When I log out and I try to login again, I have to re-enter the user, I would like to know if the EM feature on CME can mantain the last login. Thanks for your help Jose ... View more

Hi team, There is a new feature called SWAP (Toggle between two existing calls) for the 6900 IP phones,  I want to know if I can activate it in a Call Manager express   solution and how I could do it. Regards Jose ... View more

Hi team from the community,  I want to install the Cisco Security Manager 4.2 over Vmware 5.0, I Looked in the installation guide but  It only supports VMWARE 4.1. Regards Jose ... View more

Hi team, I am getting  the following error when I try to generate a new report "timezone string is not valid". I Installed the Historical report in 3 PCs with windows 7 but the error continues. thanks for your help Jose  ... View more