About jmhunter

jmhunter · 01-23-2014

Hey Folks.What would seem to be a simple setup, I am having no luckCUBE 5000 w/8.6 codeSIP trunk for phone services.I have an external number (example number of 222-111-3333) ported so that it comes down my SIP trunk. I have a translation pattern fo...

jmhunter · 03-08-2013

Hey folks,Running CUCM BE 5000 w/8.6.2 load. purchased an ATA 187 to support an alarm line for an ADT alarm service.Is there a way to NOT require an outbound call (from the alarm box) to dial a 9 before dialing the 10 digit number to the alarm compan...

jmhunter · 09-20-2012

Hey folks, me again with the basic questions I did not find from a search. CUBE 7.1.3Auto Attendant number: 5200 (for those that know me, this routes to 5299 for the Auto Attendant message)If I dial 5200 (or 5299), and the message tells me I can dial...

jmhunter · 09-17-2012

Greetings,Running a Cisco Unified Business Edition (CUBE) 7.1.3. Been asked to create a new menu for the operator message. All the requests are straight forward except for one which is to hit button 5, and have a message played giving directions to...

jmhunter · 07-31-2012

Greetings,I have a T1 handed off to me from my local ISP. I have a Cisco 2620XM w/ 12.3(1a) installed. Normally, at my other locations, I would have the T1 hit an ISP provided device and hand off to me as an Ethernet, but this was legacy before my ...

jmhunter · 01-23-2014

Sorry, yes, correct. It's a CUCM BE 5000.And you are correct, I had checkd-marked the VM checkbox, when I needed to leave it UN-checked. Thanks for pointing that out...

jmhunter · 03-12-2013

So I have an H323 gateway and I have a SIP trunk for calls. Below are the steps I have done so far. The fields with the Questionmarks (?) are where I need assistance. So, create the following?rg_ATA distribution - Top DownMembers -> 10.2.36.20 (h.3...

jmhunter · 03-11-2013

Aabueideh,Thanks. I need help on that last part, the route pattern.

jmhunter · 03-11-2013

Aabueideh,Thanks for the update.I created the partitionI created the CSS (and associated the partition to the CSS)I would not know what the number being dialed would be. I just want to set up the line to accept (in our case) the 10 digit number and...

jmhunter · 03-11-2013

Aabueideh,Thanks for the reply back. Could you get a bit more specific on how to go about this?Thanks,James

Member Since	‎04-19-2010 09:10 AM
Date Last Visited	‎08-18-2017 03:57 AM
Posts	56

User Statistics

User Activity

CFA External to External

ATA 187 Prefix a 9 automatically

Dial main number, then dial an internal extension

Recording message for a call handler

Configure T1 and passthrough IP?

CFA External to External

ATA 187 Prefix a 9 automatically

ATA 187 Prefix a 9 automatically

ATA 187 Prefix a 9 automatically

ATA 187 Prefix a 9 automatically