Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a question about having two interfaces in a virtual CPI solution with both having default gateway. In the setup process the default gateway is being set and it appears in the global configuration of CPI configuration. If I add a new virtual NI...
I am having a customer request to disable the voicemail function of some of the phones, registered in the CME(CME 10.5). They do not want to have the call transferred to voicemail after a couple of rings - the phone must continue ringing until someon...
I have a problem with a Cisco Catalyst 2950 (WS-C2950G-24-EI)I am observing throu our management system(Solarwinds), a constant growth of the memory utilization of the device. It reached arround 96-97% and then dropped down to a state of 36% by now. ...
I am having an issue with all of the Cisco IP phones not presenting the caller phone number but just "unknown number". The network infrastructure is as follows - we have two 2821 as MGCP Gateways for the CUCM, in which the phones are registered.
Th...
I am not sure, but i do not think that the telco provides such features. Our customer explained that after 3-4 calls(he didn't specify how much) the call is transferred to voicemail. And as I kno that this function with the "call-forward busy 2222 an...
Greetings,
They have already been removed. here is how the config for the phones looks like:
voice register dn 3
number 41070
name ###### - 41070
label ######
!
voice register dn 4
number 41073
name ######- 41073
label #######
Thank you Julio. This is verry helpfull for me. I will wait for the problem to occur again and I will troubleshoot it during the high utilization time. I managed to observe that the memory has dropped suddenly to its normaml condition of utilization ...
