Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, Currently configuring TEAMS direct routing to our on prem CUCM cluster via an ISR4451. We've followed this guide / document https://www.cisco.com/c/dam/en/us/solutions/collateral/enterprise/interoperability-portal/direct-routing-with-cube.pdf an...
Hi, I've setup Anyconenct to use MFA from Azure, something I've done before without too many issues. However in this instance when attempting to authenticate fia Anyconenct I get the normal authenticaiton window with 'Wrong URL' If i try from a webpa...
Hi, I have a 5545x with 2500 AnyConnect premium licenses, however when I get to about 990 connected users, additional clients struggle to connect. CPU is around 60% utilisation and the AnyConnect load is 40%. Is there a configuration setting I've mis...
I have a number of 2700 and 2800 series AP's, connected to a 2960x All of them without fault will only negotiate to 100Mbps through specific cabling, however if I disable inline power and use a PoE injector, then auto negotiation works perfectly to 1...
@Scott Leport wrote:Glad you have a fix Richard, but there are a few points / queries I'd like to raise. "Discovered you can pull a PCAP from IOS-XE" - I asked if you had done this earlier on in the thread and your response was that the traffic was c...
Thanks Roger, I spotted that earlier, made the change and it worked and then saw your response! Apologies, but also thank you for confirming! Also really appreciate the extra detail you added in the response, really helps me learn, thank you.
Hi Scott, just for a follow-up, kinda worked out what the issues were. Discovered you can pull a PCAP from IOS-XE, which as soon as i viewed in Wireshark the issue was obvious. the audio stream was coming from the inside interface of the CUBE rather ...
removing the MTP requirements simplifies the routing, but my understanding of the MTP is the traffic to from the CISCO handset goes to the MTP, in a hairpin fashion? Just to re-iterate, I really appreciate the assistance! logs are attached EDIT: Mis...
