Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
What is the different between ATM rfc1843 routed mode and bridge mode This is what i see for the configuration, some one could explain to me why is it need to configure like this? RFC1843 routed mode need to have configuration ATM protocol ip xx.xx...
hello sir,i would like to setup a syslog server and the switches will forward the log file to syslog server to analyst.please kinldy share with me Level 0 (emergency) to Level 7(debugging mode).which level i should set then only can trace the user lo...
I plan to remove the SDSL ISP modem and install SHDSL module into my Cisco 2901 and configure with the information below.ISP IP: 192.168.1.2/30 ISP GW:192.168.1.1Usernam:aaa@bbbPassword:ccccLAN IP: 10.100.100.0/24LAN GW: 10.100.100.1If i reffering to...
Hi all,due to existing VG is always hang so we are looking another for cisco voice gateway as a replacement.existing voice gateway (http://www.joyce.cz/produkt-soubory/data/webadmindemo/WELL/GATE3504/index.htm) is connect to the external sip server w...
Hi,I got the item as belowSite A - 1 unit of Netscreen VPN firewallSite B - 2 units of ASA VPN firewallI'm trying to configure a Site to Site VPN but facing some problem with active standby configuration.At first i tried Site A 1 unit Netscreen and S...
found this but not really sure what mean by routing allows multiplexing of multiple protocols over a single ATM VC but Bridging perform higher layer protocol multiplexing ?anyone can brieft me about this?http://www.cisco.com/en/US/tech/tk175/tk818/ts...
Thanks for the reply PaoloReffering to the example, i able to put in the ISP IP and route to ISP gateway but there is not username and password configure.can you share with me how to put in the static ISP IP addressand route to ISP gateway with PPPoA...
Thanks Praprama and Jathaval for the reply.i Will disable monitor on the OUTSIDE interface.Just to check for active/standby ASA firewall, 1) if i have only one ISP.can i assign the same public IP on both ASA outside interface?2)if i have two ISP. can...
