Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
i have the following topology in question: LB0----R1--------f0/0--------R2----LB0 R1 is generating a default route with "default-information originate always". If R2 does the same. R2 loses the default route from R1. Looking at the debug ospf rib, it...
Hi, I need some explanation for Call Flow and Codecs selection (with hardware based resources). I have the following scenario. [Analog-Phone-1]<--telco-->[Voice-Gateway(G.711)]<--...
HiI have a question regarding SPAN with Layer-3 link to Core/Distribution?The topology is as under:<IP-Phone>-----<cat3560>------<cat6500>------<3570>------<recording-server>Cat3560s are configured with Data and Voice VLANsThere are 5 x 3560 connecte...
Greetings, Having issue with H.323 Voice gateway. Incoming calls on PRI are not transfered to Auto-Attendant. This happens randomly but I have noticed that the frequency is higher when there are no incoming call no PRI lines. Please check Q921 and Q9...
Greetings,Having an issue with H.323 Voice gateway. Incoming calls are not transferred to Auto-Attendant. This happens randomly but I have noticed that the frequency is higher when there are no incoming call no PRI lines. (Check the attachments for d...
hi,1- If both router are originating a default route with "ALWAYS" keyword and both installs the route of each other, this could create a routing loop.2- you can always install a default route even with the "ALWAYS" keyword, if the Administrative Dis...
hi1- simply supply the output interface at the end of the command. For example: ping or ping ipv6 FE80::A8BB:CCFF:FE00:1D00 serial2/02- yes, FR should recurse to the link local address. Also if you run routing protocols, it will be essential to point...
Get yourself Dynamips/GNS3. Apart from PVDM, DSP farms, T1/E1, FXO, FXS, almost everything is possible.You can use IP Communicator (IPC)instead of hardware phones. If you don't have IPC you can also use third patry SCCP phones.A useful link to setup ...
Marijatopic,Did you restart the phone after application installation. Also make sure to switch the phone to use the wireless (always), not the packet network.Best of luck,Khalid
