Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Under the Guest Access --> Configure. If you click on Guest Portals and create a "Sponsored Guest Portal" it will bring you to a setup page to customize the portal. If you click on the "Portal test URL" on the top it uses the "IP Address". Is ther...
We have a point to point GRE tunnel which has some issues that I would like to see if I can get some guidance. When clients connect to the WLAN and are routed thru this tunnel they experience latency on some https applications. However if you chang...
I have some questions with regards to WLAN designs. The 1st question is - I would like to use a /21 subnet for a campus and would like to know if there are any issues with regards to using this size of subnet for that many clients.The 2nd question i...
I am trying to get a second set of eyes with folks that have experience configuring WS-C4506E's to support Avaya VoIP PoE phones. The following is the configuration that has been applied. I would like to see if their are any improvements that I can...
I have a question/concern with the installation of Cisco Wireless-N access points, specifically with the use of higher gain antenna's. There was an older doc that gave specific instructions to use multiples of 4.92" (NOT TO EXCEED 4 INTERVALS) as a ...
One last question.... can I do the following :interface vlan xxxip mtu 1476ip tcp adjust-mss 1436interface tunnel xxtunnel path-mtu-discoveryI would rather change it on the VLAN interface before it hits the tunnel.
I read that posting and what I gather is that from 802.11b/g to 802.11n antenna placement is not as critical. In the past we have been keeping to 19.75" apart.... to keep diversity and multipath in check. Would it be safe to assume that I can keep e...
