Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
I want to ask you guy if you have the chance to work with the 10000 series routers, and what is the CLI command to get the Rx/Tx power values for a specific interface. ( like "show controllers gigabitEthernet x/y/z/w phy" on XR routers).
IO...
Hi everyone,
Our Cisco 7600 router is showing a very high CPU on module 9, the process responsible for that is OBFL MSG bootdis, remote command on the module show the following:
CPU utilization for five seconds: 100%/0%; one minute: 99%; five minut...
Hello, I am facing an issue with the ASR9000v upgrade procedure, after executing upgrade commands (install nv satellite 100 transfer and activate) three times I still have compatible version on the show nv satellite status command:Remote version: Co...
Hi,we want to use external synchronization source ( 2MHZ) connected to BITS port on ASR 903.this is our configuration, is it complete? network-clock revertive network-clock synchronization automaticnetwork-clock synchronization mode QL-enablednetwork...
Hi Vinit,show version :Cisco IOS XE Software, Version 03.10.01.S - Extended Support ReleaseCisco IOS Software, ASR903 Software (PPC_LINUX_IOSD-UNIVERSALK9_NPE-M), Version 15.3(3)S1, RELEASE SOFTWARE (fc1)Technical Support: http://www.cisco.com/techsu...
