Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a ISR4331 that we use as a voice gateway. Currently it is on version isr4300-universalk9.03.16.04b.S.155-3.S4b-ext.SPA.bin and it works without any problems. After the upgrade it doesn't even initialize the call I ran a kron debug and found ...
We upgraded from a CME2821 to CUCM11.5. A part of this upgrade was losing the ability to utilize our paging system. Our current setup is dn *88 connects to the paging system and dn 7778 pages to our phones on the Informacast SingleWire basic system...
I'm in the processing of migrating from my cme 2821 to cucm 11.5. One of the last things I need to do is migrate the play_message_2 script I had on the old system. The script was written about 10 years ago and TAC says it may need to be upgraded to...
I've completed the installation of my CUCM 11.5 using a bootable .iso file. Now I'm trying to install CUC for the voicemail and can't get it done because there isn't a bootable .iso only a regular .iso file. I've followed the instructions at http://w...
So my faithful CME2821 has gone the way of the dodo bird. I have to get a new system installed stat. I found a Cisco partner and they recommended the ISR-4331. Now I find out I would have to buy about and extra 4-5 worth of equipment and licenses ...
Also sounds like your phones are getting the DHCP from a different source. Do you have consumer access points on your network? If so make sure they have their DHCP servers disabled.
@johnd2310 wrote:
Hi,
Not sure what you are using for the paging system but can you not integrate the paging system with infomacast using the "Singlewire Legacy Paging Interface (LPI) ?
Thanks
John
I have the basic version which only connects ...
Do you have everything the same except a new piece of hardware ? (assuming on old system everything works) ? Yes when I plug the rj-11 into the new old hardware (it is right next to the new system) it works fine.You said 'When I try to d...
