Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Catalyst wlc 9800 running 17.3.6 code (last that supports the 2702I) I have a WLAN SSID profile that if applied to a 2702I will allow old intermec ck3 handhelds running Windows Embedded Handheld 6.5 Classic CE OS 52.29354 (Build2935415i3, 12143). ht...
I have some Honeywell ct40s that have android that needs protective management frame off.https://sps-support.honeywell.com/s/article/CT40-Not-connecting-to-Cisco-Access-Pointsabove article says to disable PMF enable WPA3 (already did Wpa3 didn't fix)...
had the primary die, but secondary is up.I am fuzzy on the trick to get the active/secondary to replicate the config over to the new "blank" rma ASA.Best I recall isI need to copy all the interface commands over to the "new" blank asa.Something about...
Have 12.5 presence node. one node is showing "down". Cluster is in failover.I tried rebooting the down node (BCVVMCCMIMP01), but that didn't fix.replication runtimestateCluster Detailed View from BCVVMCCMIMP01 (2 Servers):PING DB/RPC/ REPL. Replicati...
I have searched and searched, can't seem to find how I can use command line to add an access-point. I have its mac address, ip address, already have wireless profiles, Tags, etc defined for other AP's. Can someone with better eyes point me to a doc ...
So you can't enable WPA3 and turn off PMF. Honeywell article offers two solutions. 1) enable WPA3, 2)Turn off PMF. Seems to me its either 1 & 2 but not both. Enabling Wpa3 worked "for a while" but now having issues. guess it's time to disable Wpa3 ...
The guys on reddit suggest the following.Try turning off Presence HA, and on the IM and P Servers, under Serviceability and Network Services try restarting Cisco Sync Service, Restarting Cisco Presence DB Monitor. Then re-enable HA.
would appear my access points cisco AIR-CAP3702I-A-K9 are requesting new DHCP ever 90 seconds.We have never seen that before and the AP's keep incrementing their ip's. .99, .100, .101, etc. No other device is doing this on this subnet. we see other ...
