Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Question about upgrade of the ASR-920-4SZ-AIf the rommon is upgraded to the lastest version are there any problems going from 15.x (eg 3.18) directly to 17.3.7 ?or do i need to step through 16.x first?
HiWe have a problem with unstable channels in TV-boxes on our multicast network (with other equipment such as crestron/barco) and want to separate the TV boxes on the network from the other ones. Multiple switches are used (Cat9300/9500s)I have read ...
The hard limit of 150 anyconnect peers seems to have been decided by Cisco only to sell a more expensive model. The thoughput of the hardware should be the limitation and the choice to exceed the (by Cisco setup) limit should be the made by the end c...
Hi, we discovered that after upgrade of our SMA (M100V) from 10.2.x to 11.0.0.115 that the VEEAM backup, that was working on version 10, is now failing in version 11.
It seems that something is missing in the upgraded appliance operating system that ...
Hi were trying to setup trunk ports with a number of vlans from a pair of Nexus 5548(with sw 6.0.(2)N2(5)) with a dual homed FEX Nexus 2232TM-E connected to a to a ESXi-host with 10GBase-T to a configured dvSwitch to handle the trunk vlans
With a tru...
I have done that and haven't found any definitive info in the release notes about the direct upgrade from 15.x to 17.xThere are some tacacs differences and some other minor ones that has no apparent impact on our routers.So i will make the 16.x step ...
Follow up question on upgrade of the ASR-920-4SZ-A, if the rommon is upgraded to the lastest versionare there any problems going from 3.18 directly to 17.3.7 ? or do i need to step through 16.x first?
Guilty as charged, i'm not as well into multicast as i wan't to be...IGMP is enable ONLY on the specific vlan that we use for multcast streaming, (globally enable igmp and all other vlans has igmp disabled)the setup we are using was made a couple of ...
I checked the config in the switch that supply the querier and it looks like this:I have enabled ip multicast routing in general config and also ip pim sparse-dense-mode on the vlan interface.So if disable multicast routing an remove ip pim... from t...
The problem is that if i, beside the enabled querier, also enable igmp on the second vlan, any multicast traffic will be seen on both vlans and can be used for multicast streaming.I want to totally separate the multicast from the two vlans so that th...
