Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 10G dark fiber link between an ASR 9K router and an ASR 920 that are in neighboring buildings - there is no active devices in the path, just patchpanels. We are using SFP-10G-LR SFP+ modules.
On both sides the Rx power is around -7
On the A...
I need to create a xconnect between 2 ASR 920 routers in our network - I've previously created l2vpns using bridge domains (E-LAN) but I want this to be a l2 xconnect (E-Line). We have it configured, and the status show UP UP, but the customer is hav...
We have a small Service provider network with a combination of ASR 9006 and ASR 920 routers. We have MPLS configured on the backbone network. We have a customer that has an external Ethernet circuit from London that is connected to a port on the AS...
We have 2 ASA 5515-X firewalls one at each location and we have an EVPL between these locations.
We want to configure a site-to-site vpn to act as a backup connection so if the EVPL goes down the VPN will still provide connectivity between sites. W...
Olev,
Thank you... I have another question though: I thought if you were only doing point-to-point circuits (E-LINE) it was better to use xconnect. That BG & BD were for VPLS circuits - is that incorrect? These circuits will only be point-to-poin...
Xander,
Thanks for the additional information. It is different than I thought it would be... I thought you could configure multiple service instances on the interface without using subinterfaces - but I guess I was wrong.
How would you configure...
Xander,
My drawing was incorrect and I left out an important portion of our network configuration - we are using an MPLS backbone, so although I showed only the single VLAN on the links between the ASR 9006 and the 2 ASR 920s, they are actually MPLS ...
Xander,
We have a small service provider network and we have a customer that has an external circuit from London that connects their network to ours in NYC. They are currently only using that to extend their network to their equipment at our telepor...
Aditya,
Will any routing protocols work with a site-to-site VPN? If not is there a way to change the administrative distance of static routes that the site-to-site VPN creats so we could use static routes if the EIRGP session is down? Usually stati...
