Hello, I studied some documents about the 9800-CL Wireless LAN Controller, but I couldn't evaluate it because of some privilege issues in CCO.so I have a question. The 9800-CL is IOS-XE based, right? So is it possible to use the 9800-CL as a DHCP-Ser...
Hello,
I've got a question. Is there a way to configure the Firewall rules on the Expressway via CLI (Show, add, change, remove)
I can't find anything under XConfiguration oder XCommand.
Kind regards
Nico
hello,
we've a cisco ISR 4221 with a NIM-24 Interface Card.
the Terminal Server works good, when we use Telnet. But when using SSH the console Connection becomes very slow / delayed. We need to wait 1-2 second after pressing a key before it is disp...
Hi,
I've a question. We've a centraliced Foreign WLC (virtual) and a Guest Anchor WLC.We use guest anchoring with 802.1X for our (untrusted) mobile devices.
Now we want to implement Local Switching for our Domain-Clients.
Is it possible to use the ...
Hello,
we have some Issues with our Expressway-E.
In the last Weeks we had some Call Flooding Attacks via SIP TCP.We had more than 500 Call Initiations in 15 Minutes.The source IP was always the same. Is there a way to block these flooding sources?...
XXXXXXXXXX#debug ip sshIncoming SSH debugging is on
Oct 26 2018 14:40:35.692 CEST: SSH2: starting SSH control processOct 26 2018 14:40:35.692 CEST: SSH2: sent protocol version id SSH-2.0-Cisco-1.25Oct 26 2018 14:40:35.708 CEST: SSH2: protocol version...
the CPU is in idle mode during the terminal session.
sh proc cpu history
233333333333333322222333332222222222222222222222222222222222 100 90 80 70 60 50 40 30 20 10 0....5....1....1....2....2....3....3....4....4....5....
You cannot use vWLC as a guest anchor, because the vSwitch in ESXi doesn't support dynamic learning of MAC Addresses on vNICs.
So the Problem is not the vWLC, but the hypervisor.
One Solution is to set the vSwitch in promiscuous mode. After that th...
It looks like you are right. I tried to configure a second WLAN with the same SSID and the same Authentication Methode (WPA2/802.1X) and got an error, because the Authentication Methode can not be the same on both WLANs.
It's too bad.
You're right. The vWLC is not supported as a Guest Anchor Controller, but as a foreign Controller.
Our Guest Anchor is Hardware (WLC 2504 at this Moment).
Yesterday, I read some Cisco Live Breakout Session Presentation and I found some concepts for...